Page#	Topic
1	Hot Roll Intro
2	Hot Roll Angle Specifications
3	Hot Roll Channel
4	Hot Roll Flat Bars
5	Hot Roll Square & Round Bars
6	Cold Finished Intro
7	Cold Finished Hexagons
8	Cold Finished Rounds
9	Cold Finished Flats
10	Cold Finished Squares
11	Stress Relieved Rounds
12	Pipe&Tubing Intro.
13	Pipe
14	Carbon Square & Rectangular Mechanical Tubing
15	Mechanical Tubing Specification.
16	Radii of corners on E.R.W Square & Rectangular Tubing
17	Carbon Square & Rectangular Structural Tubing
18	Round Structural Tubing
19	Sheet & Plate Intro.
20	Hot Rolled Sheet and Plate Chemistry & Mechanical
21	Sheet & Plate Thickness Tolerances
22	Expanded Metal squareness
23	Sheet out-of-square
	Sheet Flatness-Temper Rolled
	Sheet Flatness- Non-Tempered
24	Width Tolerances of Hot Rolled Mill Edge Sheet
25	Stainless Steel Introduction
26	Stainless Steel Chemical and Physical Properties
27	Stainless Steel Sheet and Plate Thickness, Width and Length Tolerances
28	Stainless Steel Tolerances for Hot Finished Flats, Rounds, Octagons and Squares.
	Stainless Steel Tolerances for Cold Finished Flats, Rounds, Octagons and Squares.
29	Aluminum Introduction
30	Aluminum Chemical and Physical Properties
31	Aluminum Sheet & Plate Tolerances:
	Thickness
	Width
	Length
32	Aluminum - Cold Finished, Drawn, and Rolled, Diameter
	Round Wire and Rod
	Drawing Stock
	Centerless ground wire and rod
	Rivet and Cold Heading Wire and Rod
Page#	Topic
33	Aluminum Thickness and Width: Cold Finish, Drawn, and Rolled
	Rectangular Wire and Rod
	Flattened Wire (round wire)
	Flattened and Slit Wire
	Distance Across Flats:
	Square, Hexagon, Octagon wire and bar
	Length:
	Specific and Multiple
	Twist:
	Bar in Straight lengths
	Flatness:
	Flat Surfaces
	Straightness:
	Rod, Bar in straight lengths other than screw machine stock
	Straightness:
	Screw Machine Stock
	Angularity:
	Squareness of saw cuts
	Corner Radii Bar:
35	Extruded Aluminum: Wire, Rod, Bar and profiles
	Length
	Straigthness
36	Twist:
37	Flatness:
	Extruded Solid Profiles
	Extruded Hollow Profiles
38	Surface Roughness:
	Squareness of cut ends
	Diameter (drawn tube)
39	Width and Depth:
	Square,Rectangular,Hexagon,and Octagonal Tube
	Wall Thickness:
	Round and other than round tube
40	Diameter:
	Extruded round tube
	Width and Depth:
	Square, Rectangular, Hexagonal and Octagonal Tube
41	Wall Thickness:
	Extruded round tube
	Wall Thickness:
	Extruded other than round tube
42	Twist:
	Other than round tube (extruded)
	Flatness
	Straightness
	Squareness of cut ends
	Angularity
Page#	Topic
43	Cold Forming Intro.
44	Cold Forming Practices
45	ASTM Subject Listings Cover Sheet
46-58	ASTM Listings
59	Carbon Steel Sheets and Plates Comparison
60	Grade 50 Comparsions
61	Quick Reference for Sheet & Plate Color Codes
62	Gage Comparison Chart